FAQ_HBS Laser System & Solutions

Resources and Support

FAQ

What To Do When Pilot Laser Not Coming Out Our engineer suggests that: 1. Check the port setting, make sure the "Red Light pointer IO---Outort" is "0".......

Motorized Z axis Not Moving Please open the left door of the supply unit and find the driver board as shown in the picture.

Marking on The Fly Text Alignment Issue When you are marking on the fly, and the marking results does not align properly, you can try the following step, and it should solve your problems.

Laser Source Not Working When your laser source does not work, please following the instruction below.

How To Test The Power Supply Unit's Voltage Follow the first two pics (1 and 2), to detach the power supply.

Rotate Marking 'Axis Must Be Homed' Error Message When you have encountered the error "Axis Must Be Homed", please follow the instruction below.

Common Problems and How To Solve Them Marking results are not clear，Marking results are not correctly located

How to Scan and Mark Tutorial of how to use scanner scan and mark

Different Marking Parameters in One Time Marking How to Set Different Marking Parameters in One Time Marking