Welcome to HBS Laser!
Your current position :Home > Resources and Support > FAQ
Resources and Support
Motorized Z axis Not Moving

Please open the left door of the supply unit and find the driver board as shown in the picture.

Please check that the six screw which pointed by the pink arrow are well tightened.

 

We would recommend you to loosen those six screws first and make sure each chip are well inserted and then tighten them one by one.

By doing this steps, normally will solve the problem.

BEIJING HBS SCIENCE & TECHNOLOGY CO.,LTD
INFO@HBSLASER.COM
(86)10 8858 5031
               
503 JINGXINGUOJI
NO.108 BEISHAGOU
HAIDIAN DIST
BEIJING,CHINA 100089